Coffee oils and fine grounds build up in the group head every time you pull a shot. Left alone, they turn rancid, make your coffee taste bitter and can block valves. A few minutes of cleaning each day keeps your espresso tasting as it should and helps your machine last.
Before you start: always follow your machine's manual. The steps below are a general guide, and some machines, especially those without a three-way solenoid valve, must not be backflushed. If in doubt, check with the manufacturer or ask us.
What you need
- A blind (blank) basket that fits your portafilter, such as our blind baskets.
- A group head cleaner powder or tablet, such as Puly Caff or the phosphate-free Puly Caff Verde.
- A group head brush, such as the speciality group head brush with 3g scoop.
- A milk system cleaner for the steam wand, such as Puly Milk.
- Clean cloths.
Every day
1. Backflush with water
Fit the blind basket in the portafilter, lock it into the group and run the pump for about 10 seconds, then stop. Pressure builds up and pushes water back through the group and out of the drain. Repeat this five or six times. Many baristas do this after every busy period.
2. Backflush with cleaner
At the end of the day, add the recommended dose of group head cleaner to the blind basket and repeat the on-off cycle five times. Remove the portafilter, rinse the basket and run a few more cycles with clean water to flush out any cleaner. Run a shot through and discard it before serving.
3. Brush the group head
With the machine on, brush around the group gasket and shower screen to remove grounds, flushing water through as you go.
4. Clean the steam wand
Wipe the wand with a damp cloth and purge it immediately after every drink. At the end of the day, soak or clean it with a milk system cleaner as directed on the product, to remove dried milk from inside the tip.
5. Soak portafilters and baskets
Soak baskets and portafilter spouts in hot water with cleaner, then rinse well. Keep wooden or plastic handles out of the solution.
Every week
- Remove the shower screen and dispersion plate (if your machine allows it), clean them in cleaner solution and rinse well.
- Empty and clean the drip tray and drain.
- Check your grinder for build-up and brush out the chute.
Every few months
- Replace the group gasket and shower screen when the gasket hardens or the portafilter locks further round than before. We stock gaskets, screens and spare parts for popular machines.
- Change your water filter on schedule. See which BRITA PURITY filter you need.
What about descaling?
Descaling removes limescale from boilers and pipes, but it is not suitable for every machine. Many manufacturers advise against descaling some dual boiler and heat exchanger machines yourself, because loosened scale can block valves. Check your manual first. For machines where descaling is recommended, use a product designed for coffee machines, such as those in our cleaning and descaling range, and follow the dosage exactly. The best approach for most machines is to prevent scale in the first place with a correctly sized water filter.
Quick routine
- Daily: backflush with water and with cleaner, brush the group, clean the steam wand, soak baskets.
- Weekly: clean the shower screen, drip tray and grinder.
- Every few months: replace gaskets and screens as needed, and change your water filter.

































