Water makes up more than 90% of every coffee, and in much of the UK it is hard. Limescale from hard water builds up in boilers, pipes and valves, causing breakdowns and shortening the life of a machine. It also flattens the taste of your coffee. A correctly sized water filter is one of the cheapest ways to protect your equipment.
BRITA PURITY C is one of the most widely used filter systems for commercial coffee machines. Choosing one comes down to four steps.
Step 1: Test your water
Do not guess your hardness. A quick test tells you which filter and which bypass setting you need.
- The BRITA temporary (carbonate) hardness test kit measures the hardness that forms limescale when water is heated. This is the figure BRITA uses to size filters and set the bypass.
- The BRITA total hardness test kit measures all hardness minerals, useful for a full picture of your supply.
Your water supplier also publishes hardness for your postcode, which is a useful starting point.
Step 2: Choose the cartridge type
- PURITY C Quell ST cartridges reduce carbonate hardness to protect against limescale, and also filter out particles and substances that affect taste and smell. This is the usual choice for espresso machines and bean-to-cup machines on hard water.
- PURITY C Fresh cartridges focus on taste and smell, for areas where scale is less of a concern.
- PURITY C AC cartridges use activated carbon to improve taste and smell.
If you are not sure which suits your water and machine, ask us and send us your test result.
Step 3: Choose the size
Cartridge sizes, such as C150, C300, C500 and C1100, are designed for increasing volumes of water. The right size depends on how much water you use and how hard it is: the harder the water, the fewer litres each cartridge can treat.
- Smaller cartridges such as the C150 suit home machines, offices and low-volume coffee points.
- Mid-size cartridges such as the C300 and C500 suit small to medium cafés.
- Large cartridges such as the C1100 suit busy cafés and high-volume machines.
BRITA publishes capacity tables showing how many litres each cartridge treats at each hardness and bypass setting. Use those figures with your expected daily water use to choose a size that you will replace roughly every 6 to 12 months.
Step 4: Set the bypass with the filter head
PURITY C cartridges fit into a filter head. Heads with an adjustable bypass, such as the 0 to 70% head, blend a share of unfiltered water back in. Getting the bypass right keeps enough mineral content for good extraction while still preventing scale. The right setting depends on your carbonate hardness and the type of machine, and is shown in BRITA's set-up instructions.
Know when to change it
A filter that has reached its capacity stops protecting your machine. Change cartridges at least every 12 months, or sooner if you reach the capacity for your water. A BRITA flowmeter counts the litres used and shows when the cartridge is due for replacement.
Summary
- Test your carbonate hardness.
- Choose Quell ST for scale protection, or Fresh or AC for taste.
- Size the cartridge to your volume and hardness.
- Set the bypass on the filter head as BRITA recommends.
- Replace on time, ideally tracked with a flowmeter.

































